Calcium Carbonate Making Powder Machine

Calcium Carbonate Making Powder Machine

Guide: The sealing structure of the Calcium Carbonate Making Powder Machine has an important influence on its operation result. Its main function is to prevent the dust from being exposed, which can ensure that the material is converted into powder as much as possible, increase its output, and reduce the environment as much as possible. Pollution, green and environmental protection, this article will briefly introduce the installation of large Calcium Carbonate Making Powder Machine sealing structure.

Calcium Carbonate Making Powder Machine sealing structure installation

The installation result of the Calcium Carbonate Making Powder Machine sealing structure directly affects the sealing effect of the Calcium Carbonate Making Powder Machine and the running quality of the hoist. Therefore, it is very important to perfect the vertical mill. Shibang Industry combines its own production and installation experience. Summarized the following installation process:

  • 1. Before installation. The sealing structure of the Calcium Carbonate Making Powder Machine needs to be familiar with the installation process before installation, and prepare all the parts, standard parts, installation tools and other items required for the installation.
  • 2. Install the hoist. The hoist head of the vertical pulverizer should be pre-installed. The upper flange of the upper flange is pasted with a 3mm thick gasket. The 30mm flange of the connecting part is also pasted with a 3mm thick gasket. Then carefully remove the hole seal.
  • 3. Install the seal seat. When the hoist main shaft of the Calcium Carbonate Making Powder Machine is assembled with the driving wheel, the connecting member with the sealing pad is first threaded onto the main shaft on both sides of the driving wheel, one side of the sealing pad is opposite to the driving wheel, and then two of the main shaft The end is respectively provided with a sealing seat equipped with a sealing ring, and the flange portion in the sealing seat is matched with the central hole in the connecting member, and the gap is used for fine-tuning the mounting position between the main shaft and the sealing seat and the main shaft and the head cover.
  • 4. Install the machine head. After the sealing seat is installed, the bearing and the bearing housing are mounted on the main shaft of the Calcium Carbonate Making Powder Machine, and the part is mounted on the headstock. After the lifting belt and the bucket are installed and debugged, the head cover is installed. Go to the headstock. Use several suitable bolts to position the connector to the side plates on both sides of the nose cover. Do not tighten the bolts to ensure that the connectors can be finely adjusted up and down, and at the same time, use several bolts to fix the connector to the lower flange. The position of the piece is such that it maintains good contact with the nose cover and the lower flange, including the corner seam.
  • 5, finishing work. When the above position of the Calcium Carbonate Making Powder Machine sealing structure is adjusted into position, the finishing work can be carried out. All the fixing bolts need to be tightened, several bolts are used to position the sealing seat, and the spindle is rotated by fine-tuning the position between the main shaft and the sealing seat. Flexible, after tightening the seal seat fixing bolts, the entire installation process is completed.